Filter
Top Products
EN-68
Reference
Measure Limit Attempting to input MIDI recording data or music
preset that has more than 999 measures.
The Digital Keyboard supports input of up to 999
measures.
Data Full Attempting to store data that exceeds the maximum
allowable number of data items.
Delete unneeded data.
Troubleshooting
Problem Cause Action
See
Page
No sound is produced when I
press a keyboard key.
1. The VOLUME controller is set to
“MIN”.
1. Rotate the VOLUME controller more
towards “MAX”.
EN-7
2. Headphones or an adaptor plug is
plugged into one of the PHONES
jack.
2. Disconnect whatever is connected to the
PHONES jack.
EN-9
3. Upper 1 icon is off. 3. Touch the Upper 1 icon to turn it on. EN-17
4. The “Speaker” SYSTEM
SETTING is off.
4. Turn on the “Speaker” SYSTEM
SETTING.
EN-55
The pitch of the Digital
Keyboard is off.
1. Digital Keyboard tuning is
incorrect.
1. Adjust Digital Keyboard tuning, or turn
the Digital Keyboard off and then back
on again.
EN-25
2. The Digital Keyboard’s key
setting is something other than
“440.0 Hz”.
2. Change the key setting to “440.0 Hz”, or
turn Digital Keyboard power off and then
back on again.
EN-55
3. A non-standard temperament
setting is being used.
3. Change the temperament setting to
“Equal”, which is the standard modern
tuning.
EN-55
4. Octave shift is enabled. 4. Change the octave shift setting to 0. EN-50
Tones and/or effects sound
strange. Turning power off
and then back on again does
not eliminate the problem.
Example:
Note intensity does
not change even though I alter
key pressure.
The “Auto Resume” feature is turned
on.
Turn off “Auto Resume”. Next, turn power
off and then back on again.
EN-55
I cannot transfer data after
connecting the Digital
Keyboard to a computer.
— 1. Check to make sure that the USB cable
is connected to the Digital Keyboard and
computer, and that the correct device is
selected with your computer’s music
software.
EN-65
2. Turn off the Digital Keyboard and then
exit the music software on your
computer. Next, turn the Digital
Keyboard back on and then restart the
music software on your computer.
I cannot record chord
accompaniment data on my
computer.
“Accomp Out” is turned off. Turn on “Accomp Out”. EN-58
I cannot store data to a USB
flash drive or load data from a
USB flash drive.
— See “Error Messages”. EN-67
Display Message Cause Action
MZX300_X500-ES-1A.indd 70 2015/10/07 15:46:52