Filter
Top Products
94
BAdditional information
Messages
If the recorder cannot carry out an
operation, error messages may flash in the
display window as follows.
BLANK DISC :
You tried to play an MD with no
recording on it.
DISC ERR :
The recorder cannot read the MD (it is
scratched or dirty). Reinsert the MD. If
the same message still appears, replace
the MD.
DISC FULL :
There is no more space to record on the
MD.
Data Save:
The MD recorder is recording
information (sounds) from the memory to
the disc. Wait until this process is
completed. Do not expose the recorder to
any physical shock, nor disrupt power
supply.
TOC Edit :
The MD recorder is recording
information (track start and end position)
from the memory to the disc. Wait until
this process is completed. Do not expose
the recorder to physical shock, nor
disrupt power supply.
BUSY :
You tried to operate the recorder while it
was accessing the recorded data. Wait
until the message goes out (in rare cases,
it may take a few minutes).
NAME FULL :
You tried to enter more than 200 letters to
label a single track or disc.
You tried to enter a total of more than
1700 letters for track or disc names.
Hi DC in :
The power supply is higher than
required. Use the recommended power
sources.
HOLD :
You tried to operate the recorder with the
HOLD switch slid in the direction of the
arrow. Slide back the switch.
LOW BATT :
The rechargeable battery or dry battery is
weak. Charge the rechargeable battery or
replace the dry battery.
MEM OVER :
You started recording with the recorder
receiving continuous vibration. Put the
recorder on the stable place and start
recording again.
NO COPY :
You tried to make a copy from a disc that
is protected by the Serial Copy
Management System. You cannot make
copies from a digitally connected source
which was itself recorded using the
digital connection. Use the analog
connection instead.
NO DISC :
You tried to play or record with no disc in
the recorder.
NO SIGNAL :
The recorder could not detect digital
input signals. Make sure that the source is
connected firmly. If the message appears
while recording, press x to end
recording.
P/B ONLY :
You tried to record or edit on a
premastered MD (P/B stands for
playback).
PROTECTED :
You tried to record or edit on an MD with
its tab in the record-protect position.
SORRY :
You tired to set Digital Sound Preset
while the “AUDIO OUT” parameter is set
to “LINE OUT.” Use the jog lever (L) to
set the “AUDIO OUT” parameter to
“HeadPhone.”
You tried to erase a track mark while
playing the MD or at the beginning of the
first track.
You tried to erase a track mark to
combine tracks the recorder cannot
combine (a track recorded in different
recording mode such as in LP2 and LP4,
or a track recorded through analog
connection and digital connection)*.
You tried to overwrite a track marrk.
You tried to press X, T MARK or REC
MODE while synchro-recording or the
joint text function is active.
* If you have recorded or erased many times
on the same MD, the data of a single track
may be scattered throughout the MD. When
the data is scattered in groups of less than 12
seconds long, the recorder will not be able to
combine the tracks.
TEMP OVER :
Heat has built up in the recorder. Wait
until the recorder cools down.