Filter
Top Products
91
Operating Instructions
On the remote control
Storing phrases while labeling
1 Do the procedure “Labeling on the
remote control” in “Labeling
recordings” (page 88) to enter a phrase.
2 After entering the phrase, press X for 2
seconds or more.
“Entry!” appears in the display and the
cursor flashes after the phrase you just
stored. You can then continue with
labeling operation.
Storing phrases using the EDIT menu
1 Press DISPLAY for 2 seconds or more,
turn the control towards . or
towards N> until “EDIT” flashes
in the display, and then press x.
2 Turn the control towards . or
towards N> until “Name Bank”
flashes in the display, and then press
x.
3 Enter the phrase you want to store,
then press x for 2 seconds or more.
“Entry!” appears in the display and the
phrase is stored.
Retrieving phrases stored in the phrase
bank
Searching for a phrase by displaying the
stored phrase one by one
1 Do the procedure “Labeling on the
remote control” in “Labeling
recordings” (page 88) until
“ :Name” or “ :Name” appears
in the display. Then press x.
2 Press X repeatedly until the first
phrase stored in the phrase bank
appears in the display.
3 Turn the control towards . or
towards N> repeatedly.
Turning the control towards . or
towards N> causes the phrases
stored in the phrase bank to appear
one by one. If you press X at this time,
the first phrase stored in the phrase
bank retrieved.
4 Press x while the phrase you want is
shown in the display.
The cursor flashes after the phrase you
just retrieved. You can then continue
with labeling operation.
Searching by the first letter of a phrase
1 When labeling a track or disc, pull and
turn the control towards VOL + or
towards – to move the cursor to the
letter which the desired phrase begins
with.
2 Press X to search.
The phrase for that letter appears in
the display. If there are two or more
phrases that start with that letter, press
X to see the next phrase.
3 Press x while the phrase you want is
shown in the display.
The cursor flashes after the phrase you
just retrieved. You can then continue
with labeling operation.
Erasing phrases
1 Press DISPLAY for 2 seconds or more,
turn the control towards . or
towards N> until “EDIT” flashes
in the display, and then press x.
2 Turn the control towards . or
towards N> repeatedly until
“BankErase” appears in the display,
and then press x.
3 Turn the control towards . or
towards N> repeatedly until the
phrase you want to erase appears, and
then press x.
“Erase!” appears in the display and the
phrase is erased.
If there is no phrase stored in the
phrase bank, “EMPTY” appears in the
display.
To cancel the operation, press DISPLAY
for 2 seconds or more.