Filter
Top Products
81
Operating Instructions
Adjusting the recording level
manually (Manual recording)
See the illustration in the Japanese text
(page 29).
When you record, the sound level is
adjusted automatically. If necessary, you
can set the level manually.
Note
Adjust the recording level while the recorder
is in standby mode. You cannot adjust it while
recording.
1 While holding down X, press and
slide REC to the right.
The recorder stands by for recording.
2 Press the jog lever (L), flip the lever
until “RecVolume” flashes in the
display, and then press the lever again.
3 Flip the jog lever (L) until
“ManualREC” flashes in the display,
and then press the lever.
To switch back to the automatic level
adjustment, repeat the procedure from
step 2 and press the lever (L) while
“Auto REC” flashes in the display.
4 Play the program source.
5 While observing the level meter in the
display, adjust the recording level by
flipping the lever (L).
Set the level so that the input lights up
around the fifth segment on the level
meter. If the maximum input lights up
the ninth segment, lower the level.
Recording does not start in this step.
If your source is an externally
connected component, be sure to cue
the source to the begining of the
material to be recorded before you
start playback.
6 Press X again to start recording.
Notes
•The recording level cannot be adjusted
while recording is in progress. If you want
to adjust the recording level after you have
started the recording, press X to pause the
recorder. Then do the procedure from step 5.
•You cannot adjust the recording level
manually during synchro-recording.
Setting the clock to stamp the
recorded time
See the illustrations in the Japanese text
(page 32).
To stamp the date and time on the MD
when you record, you first need to set the
clock.
1 Press the jog lever (L) while no disc is
inserted or the recorder is stopped.
2 Flip the jog lever (L) until “CLOCK
SET” flashes in the display, and then
press the lever.
The digits of the year flash.
3 Change the current year by flipping
the jog lever (L) and press to enter.
The digit of the month flashes.
4 Repeat steps 3 to enter the current
month, date, hour, and minute.
When you press the jog lever (L) to
enter the minute, the clock starts
operating.
If you make a mistake while
setting the clock
Press x, and set the clock again from step
2. You can skip a step by pressing the jog
lever (L).
To display the time in the 24-hour
system
Press X while setting the clock. To change
the clock to the 12-hour system, press X
again.
To maintain the correct time
Once you set the clock, it will keep correct
time as long as the recorder is connected to a
power source, such as the rechargeable
battery, alkaline dry battery, or AC power
adaptor. However, if no power source is
connected, the clock setting will change back
to the factory setting after about 3 minutes.
When changing the rechargeable battery or
alkaline dry battery, make sure to do it within
3 minutes.
Note
Make sure the time is correctly set if you want
the time stamp to be accurately recorded for
an important recording.