Filter
Top Products
84
To adjust the sound quality
(Digital Sound Preset)
See the illustrations in the Japanese text
(pages 37 and 38).
You can make adjustments to the sound
quality to suit your taste, and then store
two sets of these adjustments.
Settings can be stored to the Personal Disc
Memory.
1 Press SOUND on the remote control
repeatedly to select “SOUND1” or
“SOUND2”.
2 During playback, press SOUND for 2
seconds or more.
The recorder changes to bass-setting
mode. Pressing the SOUND button for
2 seconds again changes the recorder
back to treble-setting mode.
3 Turn the control on the remote control
towards . or towards N>
repeatedly to adjust the bass or the
treble.
Pressing the SOUND button for less
than 2 seconds toggles the display
between “SOUND1” and “SOUND2”.
When you press SOUND for a short
time while adjusting bass or treble, the
setting for that sound is entered and
the display switches to the other sound
setting.
The sound can be adjusted in 8 steps (–
4, –3, ...±0, ...+2, +3).
4 Press RPT/ENT .
The sound settings are saved and the
playback display appears again.
To select a preset sound
Press the jog lever (L), flip the lever until
“SOUND1” or “SOUND2” flashes or nothing
appears in the display, and then press the
lever again.
Factory settings of the Digital Sound
Preset
Factory settings of the Digital Sound Preset
are the followings:
• “SOUND1”: bass +1, treble ±0
• “SOUND2”: bass +3, treble ±0
Notes
•You cannot set the Digital Sound Preset with
the recorder.
•Digital Sound Preset becomes inoperative
when the “AUDIO OUT” parameter for the
i/LINE OUT jack is set to “LINE OUT”. In
this case, set the “AUDIO OUT” to
“HeadPhone” (page 77).
•Sound distortion may occur when you use
Digital Sound Preset. In this case, lower the
volume or change the settings.
•Changing to another Digital Sound Preset
during a recording operation will not affect
the quality of recorded sound.
To change playback speed
(Speed Control)
See the illustrations in the Japanese text
(page 39).
The playback speed can be adjusted in 7
steps (80%, 85%, ...100%, 105%, 110%).
Setting can be stroed to the Personal Disc
Memory.
1 Press DISPLAY on the remote control
for 2 seconds or more during playback.
2 Turn the control on the remote control
towards . or towards N> until
“SPEED” flashes in the display, and
then press x on the remote control.
The recorder changes to speed-setting
mode.
3 Turn the control towards . or
towards N> to select the playback
speed.
“+” shows the normal speed and the
cursor shows the playback speed you
are selecting.
4 Press x to set the playback speed.
“S” appears in the display when the
speed is changed.
Notes
•You cannot change playback speed with the
recorder.
•The playback sound will be affected by the
playback speed.
•All settings will be lost when you remove
the disc from the recorder.
Notes on program setting.
•All program settings are lost when the disc
is removed from the recorder.
•If the recorder is stopped and left inactive
for 5 minutes in the middle of a
programming operation, the tracks selected
up to that point are entered as the program.