Filter
Top Products
89
Operating Instructions
4 Turn the control towards . or
towards N> to select a letter and
press x to enter.
The selected letter stops flashing and
the cursor moves to the next input
position.
Press X to switch between katakana,
the alphabet, symbols/numbers, and
phrases (if phrases are stored in the
phrase bank).
Pull and turn the control towards VOL
+ or towards – to move the cursor to
left or right.
Turn the control towards N> when
inputting alphabet, symbol or numbers
to change the letter to the one before/
next one. Turn towards . to go
back.
Press DISPLAY to insert a blank space
to type in a new letter.
Press DISPLAY for 2 seconds or more
to cancel labeling.
Press PLAYMODE to delete a letter
and move back all following letters to
the left.
5 Repeat step 4 and enter all characters
of the label name.
6 Keep pressing x for 2 seconds or
longer.
The track or disc is labeled.
Labeling a track during playback
1 Insert a disc and play the track you
want to label.
2 Press DISPLAY for 2 seconds or more,
turn the control towards . or
towards N> until “EDIT” flashes
in the display, and then press x.
“ : Name” flashes in the display.
3 Press x.
The disc is ready to be labeled.
4 Follow steps 4 to 6 of “Labeling a disc
during stop” above.
Labeling a track or a disc during
recording
1 Press DISPLAY for 2 seconds or longer
during recording, turn the control
towards . or towards N> until
“EDIT” flashes in the display, and then
press x.
“ : Name” flashes in the display.
2 To label a track, press x.
To label a disc, turn the control
towards . or towards N> until
“ : Name” flashes in the display,
then press x.
3 Follow steps 4 to 6 of “Labeling a disc
during stop” above.
To cancel labeling, press DISPLAY for 2
seconds or more.
Notes
•When the recording is stopped while
labeling a track or a disc during recording,
or when the playback moves on to the next
track while labeling a track during playback,
the input at that point is entered
automatically.
•“LP:” has automatically been added at the
beginning of the track names for tracks
recorded in LP2 or LP4 mode.
Relabeling recordings
Follow the steps corresponding to the labeling
method until the disc or track is ready to be
labeled. Enter a new character over the one
you want to change, then press the jog lever
(keep pressing x for 2 seconds or more on the
remote control).
Notes
•Track and disc titles that were entered in
Japanese katakana characters will appear in
Roman letters on minidisc players that do
not support the display of katakana
characters. Such titles will be marked with a
“^” at the beginning and the end.
•You cannot relabel premastered MDs or
label MDs that have not been recorded.
•The recorder cannot rewrite a disc or track
name of more than 200 letters that was
created by another device.