Filter
Top Products
51
52
F. Installing Forward-Facing
F-5 Install Forward-Facing
With Vehicle Belts
Child Restraint Must be
Upright
R
otate recline stand out
and push upward to lock in
position.
Do not use the LATCH system along with the
vehicle belt. Secure LATCH belts when using
the vehicle belts.
Check the vehicle belt before each use. Use only
if the belt is tightened properly and securely.
Failure to follow these warnings can result in
serious injury or death.
Secure LATCH Belts
You MUST fasten the LATCH
belt hooks to the side of
plastic shells as shown
when using the vehicle seat
belts.
2.
1.
continued on next page.
Place Child Restraint
in Vehicle
Forward-Facing
Place child restraint flush
against the back of the
vehicle seat forward-
facing in the back seat.
3.
Note: Review the section D-4 to determine what kind
of vehicle belts you have. Review your vehicle’s owner
manual for vehicle seat belt use.
Installation Tip:
Loosely attach the
top anchorage
hook (tether)
before threading
the vehicle belt.
Consult vehicle’s
owner manual for
specific location.
NOTE:
If you cannot use the
top anchorage strap (tether),
attach the hook to the recline
stand as shown.
Tighten
tether to remove the slack.
Thread Vehicle Belt
Thread the vehicle lap
or lap/shoulder belt
combination through the
forward-facing belt slot
and out the other side.
Buckle vehicle belt.
4.