Filter
Top Products
C-9 Installing Harness System
Install Buckle
Fit the buckle’s metal
retainer through the slot
in the child restraint. Red
button must face out.
Pull buckle’s metal
retainer completely
through pad and plastic
shell from bottom of child
restraint.
1.
Check Buckle
Pull up on buckle to make
sure it is secured. The
buckle must not pull out.
2.
3.
C. Basic Use
26
Thread Harness Strap
Thread the harness down
through slot on left side
of plastic shell
(1) and up
through slot on right side
(2).
NOTE: Make sure sewn
end of the harness strap
loop faces the buckle
before starting.
Take both ends of the
harness and make them
even in length.
NOTE: Make sure
harness tightening strap
is between the harness
strap and plastic shell as
shown.
1
2
continued on next page.
Remove Seat Pad
Pull pad off the top of
child restraint and around
headrest.
5.
Replace child restraint pad by reversing order; Starting
from bottom of child restraint, slip pad on plastic shell; pull
harness tightening strap through pad. Make sure pad is
under headrest and attach the fastening strip behind the
headrest. Replace lower and upper harness guides. Replace
headrest pad.
Attach all of the elastic straps.
Rethread harness (see section C-9).
Cleaning Pad
Hand wash pad with warm sudsy water, rinse clean and air
dry. Spot clean the harness straps. Do not use bleach or
use other harsh cleaners. Do not dry clean.
Do not use child restraint without the pad.
Undo Fasten Strip Behind
Headrest
Lower headrest to lowest
position and undo the
fastening strip behind the
headrest. Pull back pad
down from behind the
headrest.
4.
25