Filter
Top Products
Planning the installation 7
Item Name Description
11
Onboard Administrator module Hot-pluggable enclosure management module. One
module is required to manage the components
installed in the enclosure. To provide redundant
enclosure management, you can install an optional
second module.
12
Onboard Administrator blank A mandatory cover installed in any unused Onboard
Administrator bay
13
Interconnect blank A mandatory insert installed in any unused
interconnect bay
14
Interconnect module (quantity and type as
ordered)
Any of several components, such as pass-thrus or
switches that enable communication between the
blade and the enclosure
15
Onboard Administrator tray Hot-pluggable tray that houses up to two Onboard
Administrator modules and provides two enclosure link
connectors, the rear enclosure UID, LED, and switch.
16
HP BladeSystem Insight Display A display that provides information about the health
and operation of the enclosure
17*
Power retention ties (single-phase enclosures
only)
Tie straps that help prevent single-phase power cables
from disconnecting from the power connectors
18*
Documentation CD A CD containing detailed documentation on using the
enclosure
19*
Hard copy installation instructions for
blades, options, and interconnects
The printed installation instructions
20*
Installation checklist A checklist to guide you through installation of the
enclosure and components
* Not shown
Rack requirements
The enclosure is compatible with the following racks:
• All HP 10000 and 10000G2 Series racks except the HP 10614 rack.
NOTE: The system is optimized for 10000 Series racks.
• Telco racks
• Third-party rack cabinets that meet the following requirements:
o Width: 48.3 cm (19 in)
o Depth:
— 88.9 cm (35 in) maximum clearance between front and rear RETMA rails
— 62.7 cm (24.7 in) minimum clearance for round-hole racks
— 63.5 cm (25 in) minimum clearance for square-hole racks
o Clearance—7.6 cm (3 in) minimum clearance between rear RETMA rails and rear rack door to
accommodate system cabling
o Clearance—4.5 cm (1.75 in) minimum clearance between rack face and inside of front rack door