Filter
Top Products
Installation 21
Installation
Installation overview
To set up and install the enclosure:
1. Disassemble the enclosure ("Disassembling the enclosure" on page 21).
2. For rack-free installations ("Rack-free installation" on page 24), set up the enclosure on an appropriate
surface, then install the rear cage and enclosure components.
3. For rack installations, install the enclosure into the rack ("Installing the enclosure into the rack" on page
26) then reassemble the enclosure.
4. Install the enclosure components ("Component installation" on page 29) into the enclosure.
5. Connect the enclosure components ("Cabling and powering up the enclosure" on page 56) in the
enclosure.
6. Connect the AC power cables and power up the enclosure ("Powering up the enclosure" on page 59).
7. Configure the enclosure ("Running the Insight Display installation steps" on page 65) using the Insight
Display.
Disassembling the enclosure
Before installing the enclosure into the rack, you must disassemble the enclosure. Because a fully-populated
enclosure can weigh up to 217.7 kg (480 lb), remove the components and the rear cage from the enclosure
to make moving and installing the enclosure easier. Two people should work together to remove the rear
cage from the enclosure.
The empty enclosure with the rear cage installed weighs 58.6 kg (129 lb). When the enclosure is
disassembled, the empty enclosure without the rear cage installed weighs 35.5 kg (78 lb). The empty rear
cage weighs 23.2 kg (51 lb).