Filter
Top Products
2 Insert four non-rechargeable batteries (Fig. 4).
Note: Make sure the + and - poles of the batteries point in the right direction.
3 Reattach the lid and turn the locking knob clockwise with a coin or screwdriver.
Note: When the batteries are low, the power-on light on the baby unit ashes red.
Parent unit
The parent unit runs on a rechargeable battery pack (included).
Charge the parent unit before you use it for the rst time or when the power-on light on the
parent unit ashes red to indicate that the battery pack is low.
1 Slide the lid of the compartment for the rechargeable pack downwards to remove it (Fig. 5).
2 Insert the plug of the rechargeable battery pack into the socket inside the compartment (1).
Then put the rechargeable battery pack into the compartment (2) (Fig. 6).
Make sure your hands and the unit are dry when you insert the rechargeable battery pack.
3 Slide the lid back onto the parent unit.
4 Place the parent unit in the charger (1), put the small plug in the charger and put the adapter
in a wall socket (2) (Fig. 7).
During charging, the charging light on the charger lights up red continuously.
5 Leave the parent unit connected to the mains until the battery pack is fully charged.
When the battery pack is fully charged, the charging light gradually dims.
When you charge the parent unit for the rst time or after a long period of disuse, switch it
off and let it charge continuously for at least 14 hours.
When the battery pack is fully charged, the parent unit can be used cordlessly for up to 10
hours.
Note: When the parent unit is charged for the rst time, the operating time is less than 10 hours. The
battery pack only reaches its full capacity after you have charged and discharged it three times.
Note: When the battery pack is low, the power-on light on the parent unit ashes red.
Note: When the battery pack is completely empty, the parent unit automatically switches off and loses
contact with the baby unit.
Note: When the parent unit is not connected to the mains, the battery pack gradually discharges, even
when the parent unit is switched off.
1
Place the two units in the same room to test the connection (Fig. 8).
Make sure the baby unit is at least 1 metre/3 feet away from the parent unit.
2 Press and hold the on/off button 3 on the baby unit until the green power-on light goes
on. (Fig. 9)
3 Turn the volume control to switch on the parent unit and to set the volume to the level you
prefer (Fig. 10).
The green power-on light goes on.
The LINK light on the parent unit ashes green until connection has been established.
This takes up to 30 seconds. The LINK light on the parent unit then lights up
green continuously.
Note: If no connection can be established, the LINK light on the parent unit ashes red.
4 Place the baby unit at least 1 metre/3 feet away from your baby (Fig. 11).
,
,
-
-
,
,
ENGLISH8