Filter
Top Products
3 Connect the AC power adapter (21) to the DC 9V —<± socket (20)
of the Baby Unit and insert the mains plug into the mains supply.
4 Use the TONE/PULSE selector (15) to select tone dialling or pulse
dialling.
Always use tone dialling unless your telephone company only supports
pulse dialling. Please check with your telephone company when in doubt.
5 Press the POWER button (7).
> The display (9) lights up and the Power light (8) lights up green.
> After a few seconds ‘M1’ starts blinking on the display.
The Baby Unit is now in Quick install mode and you are asked to enter:
– A call-up phone number (M1).This is the number the Baby Unit is
going to call when sound is detected.
– A 4 digit PIN code (PIN).The PIN code has to be entered when
placing calls to the Baby Unit.
– A sensitivity time ( ).This is the time after which the Baby Unit
calls the call up number when sound is detected.
The default is 10 seconds.
6 Enter the call-up phone number, PIN code and sensitivity time using the
numeric keypad (5) and confirm each entry by pressing the OK button
on the keypad (5).
> The Baby Unit is now ready for use in Dial-up mode and returns to
regular baby monitor mode.
Notes:
– Optional conversion connectors are available at your telephone supplier, in
case your telephone cable does not fit.
– With the C(lear) button on the keypad (5) you can always clear the last
entered digit.
– If you do not wish to change the default sensitivity time ( ),
simply press the OK button on the keypad (5).
– If no button is pressed for 5 seconds the Baby Unit enters regular baby
monitor mode.
– To undo the installation, press the RESET button (13) for more than
5 seconds.
– For more detailed information on programming and on resetting the Baby
Unit, see ‘Advanced settings’.
ENGLISH 9