Filter
Top Products
Getting your baby monitor ready
Battery back-up
As soon as the batteries are inserted battery back-up will be activated. In
case of mains failure during mains operated use, the unit will give you a
call and automatically switch to battery operated use.The unit
automatically switches back to mains operated use when the mains
returns.
Inserting the batteries in the Baby Unit
1 Ensure the Baby Unit is disconnected from the mains.
2 Remove the battery compartment cover (12) using a screwdriver.
3 Insert four 1.5V, alkaline, LR6 batteries using the + and - configuration
inside the battery compartment. The batteries are not included.
Only use 1.5V LR6/AA non-rechargeable alkaline batteries.
4 Put the battery compartment cover (12) back in place.
> The Baby Unit can now be used cordlessly in both regular baby monitor
mode and Dial-up mode. It operates for approximately 30 hours on
fresh batteries
> When the battery indicator on the display (9) is empty and blinking, the
battery power is low.You should install new batteries.
Tips:
– Switch off the Baby night light to save battery power when the Baby Unit is
being battery operated.
– Remove batteries if the unit is not used for a longer period of time.
– Remove empty batteries from the Baby Unit.
Installing the units for use in regular baby monitor
mode
1 Position the Baby Unit at least one metre away from your baby.
Never place the Baby Unit inside the baby’s cot or playpen.
2 Set the CHANNEL selection switches (2 and 30) to the same channel on
both units.
3 Connect the AC power adapter (21) to the DC 9V —<± socket (20)
of the Baby Unit and insert the mains plug into the mains supply.
4 Move away from the Baby Unit with the Parent Unit.
If units are positioned too close to each other, a high-pitched noise can be
heard.
ENGLISH 7
TONE/PULSE
LINE OUT
L
I
N
E
IN
RESET
+
+
+
+
+
+
+
+
+
+
+
+
TONE/PULSE
LINE OUT
L
I
N
E
IN
RESET
+
+
+
+
+
+
+
+
A
B
C
D
C
H
A
N
N
E
L