Filter
Top Products
ENGLISH14
5 If you wish to store another telephone number press the M(emory)
button (1) again to select a memory location and repeat steps 3 and 4.
Notes:
–With the C(lear) button on the keypad (5) you can always clear the last
entered digit.
– When no key is pressed for 5 seconds the Baby Unit leaves the
programming mode.
– In case your telephone network requires a short pause between numbers
(e.g. for selecting an outside line), a pause can be stored by pressing the
button on the keypad (5).The display will next show a ‘P’.
Clearing telephone numbers
1 Press the PRG (Program) button on the keypad (5).
> ‘M1’ blinks on the display.
2 Press the M(emory) button (1).
> ‘M1’ lights up on the display together with the telephone number.
3 Press the ‘0’ button on the keypad (5).
4 Briefly press the C(lear) button on the keypad (5).
> The icon starts flashing and the number disappears from the display.
The number has now been cleared and the memory location is available
again.
5 Repeat steps 2, 3 and 4 to clear other telephone numbers.
Note:To clear all numbers,you can also reset the unit.
All user settings will be reset to the factory default.
See ‘Resetting the Baby Unit’ for more information.
Storing your PIN code
When using the Baby monitor in Dial-up mode, use of the PIN code is
necessary. It prevents others from listening to your baby.The PIN code
has to be entered when placing calls to the Baby Unit
1 Press the PRG (Program) button on the keypad (5).
2 Press the PIN button on the keypad (5).
> ‘PIN’ and ‘– – – –’ start flashing on the display.
3 Use the numeric keypad (5) to enter the required PIN code.The code
must consist of 4 digits.
4 If the code is correct, press the OK button on the keypad (5) to store
the code in the memory.