Filter
Top Products
ENGLISH16
Troubleshooting
First check the points listed belowif an error occurs. If you are unable to
resolve the problem by following the solutions given below, contact the
helpline or consult your dealer. Under no circumstances should you try to
repair the set yourself as this will invalidate the warranty.
Problem Possible cause Solution
System check Units are out of range or there is Move units closer together to
light flashes red interference from another restore the link. Remove the other
and/or system FM source. FM source.
check alarm
sounds Baby Unit is not switched on. Press POWER button (7).
Power light does Parent Unit: unit is not turned on. Turn VOLUME ON/OFF control (29)
not light up downwards.
AC power adapter (34) Insert AC power (34) adapter into the
not inserted into the mains supply mains supply and/or into the unit’s
and/or into the charging base (33). charging base (33).
Batteries are low. Recharge batteries.
Baby Unit: unit is not turned on. Press POWER button (7).
AC power adapter (21) Insert AC power (21) adapter into the
not inserted into the mains supply mains supply and/or into the unit’s
and/or into the unit (20). charging basre (20).
Batteries are exhausted. Replace batteries.
High pitched Units are too close together. Move Parent Unit away from Baby
noise Unit.Turn VOLUME ON/OFF
control (29) on Parent Unit upwards.
Parent Unit AC power adapter (34) Insert AC power (34) adapter into the
batteries do not not inserted into the mains supply mains supply and/or into the unit
charge and/or into the charging base (33). the charging base (33).
Battery life is at an end. Replace battery pack.
No sound Volume on Parent Unit is set Turn VOLUME ON/OFF control (29)
too low. downwards.
Power light Batteries are low or empty. Parent Unit: - recharge battery pack.
flashing Baby Unit: - replace batteries or
connect to mains power.