Filter
Top Products
Pelco Manual C539M-A (12/01) 11
2.1.4.5 Channel or Address Select
If DIP 1-7 is set to the OFF position, the translator responds to addresses 1-16. If DIP 1-7 is
ON, the translator responds to addresses 17-32. Therefore, in a cascaded configuration,
DIP 1-7 on the first translator would normally be set to OFF (for the first 16 addresses) and
DIP 1-7 on the second translator would be set to ON for the second set of 16 addresses
(17-32). The important thing is that DIP 1-7 on both translators in a cascaded configuration
are not set the same (both ON or both OFF).
Figure 10. Channel or Address Select
2.1.4.6 Equipment Type
The setting of this DIP switch position is relevant only if DIP 1-1 or 1-2 is set for 32-bit
Coaxitron on any x8 grouping on a translator. If the 32-bit setting is chosen on any x8
grouping, then DIP 1-8 excludes the use of both Intercept and Spectra receivers on the
same translator at the same time. You must make a choice between using one equipment
type or the other for the translator in question.
Figure 11. Equipment Type