Mitsubishi Electronics AJ65BT-D75P2-S3 Model Vehicle User Manual


 
12 - 12 12 - 12
MELSOFT
12. USEFUL FUNCTIONS
12.3 Copying the Data
Copy the positioning data, start block data, parameters and servo parameters set to
the project axis-by-axis.
Alternatively, copy the set start block data to the other block.
12.3.1 Copying the data on an axis basis (Axis copy)
PURPOS
E
Using the axis copy function, copy the positioning data, start block data,
parameters and servo parameters of any axis to the other axis of the same project.
When the axis copy is performed, data may not match between the axes. After
performing the axis copy, make error check (refer to Section 9.2.1).
BASIC OPERATIO
N
1. Display any of the positioning data (refer to Section 9.1), start block data (refer
to Section 9.3), parameters (refer to Section 8.1) and servo parameters (refer
to Section 8.2) on the main screen.
2. Click the [Edit] [Axis copy] menu.
3. Set the axis of the copy source, the types of the data to be copied, and the axis
of the copy destination.
4. Click the "OK" button.
DISPLAY/SETTING SCREEN
DISPLAY/SETTING DATA
Item Description
Copy source data
Choose the axis of the copy source and set the data to be copied.
The start block data includes condition data and indirect data.
Copy destination Set the axis of the copy destination.
"OK" button Click this button to copy the data.