Filter
Top Products
W6-LI System Board Manual
Chapter 3: Installing the W6-LI
18
Installing the W6-LI
Installation of the W6-LI system board depends on the type
of case you use. The W6-LI is designed for the standard
ATX form factor and must be installed in an ATX chassis.
NOTE: If you are unfamiliar with installing a system board,
Micronics highly recommends that you read the computer
user’s manual or contact your dealer’s technical support
department.
Tools Required
Micronics recommends using the following tools to in-
stall the W6-LI:
❏ Small Phillips screwdriver
❏ Tweezers or a pair of needle-nose pliers
❏ Tray (to hold loose screws)
Equipment Required
Micronics recommends using the following equipment with
the W6-LI for a typical configuration:
❏ ATX chassis with standard hardware.
❏ A high-quality ATX power supply capable of providing
continuous power within a 3 volt range. A power filter
may be used with a noisy AC power source.
❏ PS/2 mouse and compatible keyboard.
❏ Eight ohm speaker.
❏ Standard ribbon cables for internal connections.
❏ Standard power cord (grounded).
❏ Heat sink with cooling fan for each CPU (required).