Filter
Top Products
W6-LI System Board Manual
Chapter 2: Configuring the W6-LI
14
Table 2-3 lists the jumper settings for the ISA Bus clock frequency.
Table 2-4 lists the jumper settings to enable or disable the system power
supply.
Table 2-5 lists the jumper settings to clear the CMOS settings. With your
computer's power off, close pins 2-3, wait ten seconds and place the
jumper back on pins 1-2. (The jumper must be placed back on pins
1-2 for the system to function properly.)
NOTE: This will reset all BIOS default settings. Any changes you have made
will be lost.
Table 2-6 lists the jumper settings to select the optional onboard sound.
Jumper Host Bus Speed ISA Bus Speed Setting
W12 60MHz (default)
66MHz (default)
7.50MHz
8.25MHz
Close
Close
Table 2-3: ISA BUS Clock Settings
Jumper Function Settings
W14 Enable Sound (default)
Disable Sound
Close
Open
Table 2-6: Onboard Sound Selection
Jumper Function Settings
W13 Normal (default)
Reserved
Open
Close
Table 2-4: System Power Supply Setting
Table 2-5: Clear CMOS Settings
Jumper Function Settings
W11 Normal (default)
Clear CMOS
1-2
2-3