Filter
Top Products
MG-3D/M MULTIPURPOSE GRID AND ACCESSORIES
PN: 05.132.036.01 B2
Page 28 of 32
Meyer Sound Laboratories Inc.
www.meyersound.com
T: +1 510 486.1166
F: +1 510 486.8356
MVE-MILO VERTICAL EXTENSION BARS
In a MILO array, MFAL-MILO front and MRAL-MILO rear AlignaLinks at the cabinet corners couple the units for either
flying or stacking, and allow nine positions from 0° to 5° of cabinet splay (0°, .5°, 1°, 1.5°, 2°, 2.5°, 3°, 4°, 5°). For ap-
plications where the desired splay angle is greater than the full 5° capability of the MRAL-MILO rear AlignaLinks, the
MVE-MILO vertical extension bars can help.
TIP: The MVE-MILO vertical extension bars are most useful when you need to minimize high-frequency
reflections in a specific area – such as a balcony face in a theatre or glass in an arena – in your MILO
array’s vertical coverage. By increasing the angle between the two loudspeakers aimed at the surface you
need to miss, you reduce the amount of sound reflected from that surface, and maximize other areas requiring
coverage.
The two MVE-MILO extension bars replace the triangular MFAL-MILO front AlignaLinks on the upper cabinet where
the extended angle is required. Using the MVE-MILO bars, you can extend the splay angle between loudspeakers by
an additional 3°, 6° or 9°. This effectively provides up to 12° (3° maximum of the MRAL-MILO rear AlignaLinks plus 9°
maximum of the MVE-MILO) splay angle. Note that on the MRAL-MILO, 4° and 5° are not used.
NOTE: The same quick release pins (3/8" x 1.125") used for the MFAL-MILO front AlignaLink are used
with the MVE-MILO vertical extension bars. MVE-MILO can be stored the same way as the MFAL-
MILO and can be used to secure a cabinet to the MCF-MILO caster frame.
NOTE: Using too many MVE-MILO bars in a single array may create excessive splay angles, severely
degrading array behavior and directionality.
CAUTION: When using the MVE-MILO extension bars, the total weight of the array should be always
be calculated and be within specifications before flying an array. Do not exceed the MG-3D/M grid load
ratings listed in Chapters 2 and 3 of this guide.
List of Contents: MVE-MILO Vertical Extension Bars (
40.132.130.01)
Qty Part Number Description
A
2 61.132.037.02 MVE-MILO Vertical Extension Bar
A