Filter
Top Products
MG-3D/M MULTIPURPOSE GRID AND ACCESSORIES
PN: 05.132.036.01 B2
Page 27 of 32
Meyer Sound Laboratories Inc.
www.meyersound.com
T: +1 510 486.1166
F: +1 510 486.8356
PBF-MILO PULL-BACK FRAME
The up and down tilt of the MG-3D/M multipurpose grid and the complete MILO array hung underneath can be ad-
justed using chain motors, or differing lengths of steel cables or chain lengths. The rigging connections between MILO
loudspeakers using the MFAL-MILO front AlignaLinks and MRAL-MILO rear AlignaLinks are rigid, and in most applica-
tions array tilt can be achieved by adjusting the angle of the MG-3D/M grid. For applications where you need an ex-
treme tilt and motor adjustments alone are not enough, the PBF-MILO pull-back frame can be attached to the lowest
MILO cabinet in the array. The MTB-2D/M kit and an extra motor or lifting device are required for this configuration.
CAUTION: When using the PBF-MILO pull-back frame, the total weight of the array should always be
calculated and be within specifications before flying the array. Do not exceed the MTG-3D/M grid load
ratings listed in Chapters 2 and 3 of this guide.
NOTE: If a severe up tilt is needed, the MTB-2D bars can be reversed, allowing you to install the PBF-
MILO pull-back frame to the front of the array.
NOTE: Use the array rigging calculator to compute load and center-of-gravity data. Visit www.
meyersound.com/arraycalculator to find out how to download the calculator.
List of Contents: PBF-MILO Pull-Back Frame (
40.132.034.01)
Qty Part Number Description
A
1 40.132.034.01 PBF-MILO Pull-Back Frame
NOTE: The approxi-
mate combined weight
of the PBF-MILO pull-back
frame and MTB-2D transition
kit is 42 lbs (19.41 kg).
A