Filter
Top Products
MG-3D/M MULTIPURPOSE GRID AND ACCESSORIES
PN: 05.132.036.01 B2
Page 15 of 32
Meyer Sound Laboratories Inc.
www.meyersound.com
T: +1 510 486.1166
F: +1 510 486.8356
MILO GROUND-SUPPORTED CONFIGURATIONS
By simply flipping the MG-3D/M multipurpose grid over from its flown configuration and installing the levelling feet,
the MG-3D/M grid can be used to provide ground support for a MILO array. The MG-3D/M grid provides two positions
— front and rear. Either position may be used to stack MILO loudspeakers, although the front position is most useful for
stacking a predominantly up tilted MILO array. In ground-supported configurations, MFAL-MILO front AlignaLinks and
MRAL-MILO rear AlignaLinks connect the MG-3D/M grid to the first MILO with the same vertical orientation used as if
the MG-3D/M were simply another MILO cabinet, providing from –1° to 4° up tilt between the MG-3D/M grid and the
first loudspeaker when using a MILO loudspeaker as the first element of the array.
NOTE: The angles engraved on a MILO rigging frame guide you when setting the splay angles between
MILO cabinets. To set the angle between the MG-3D/M grid and the first MILO in your ground-
supported array, the actual angle is the engraved angle minus 1°. For example, if you set the angle to the 5°
hole, the actual angle between the MG-3D/M grid and the MILO will be 4° of up tilt.
Install the MFAL-MILO front and MRAL-MILO rear AlignaLinks as shown into the MG-3D/M grid, using the 3/8" x 1.5"
quick release pins (QRPs).
CAUTION: When ground supporting a MILO array on an MG-3D/M grid, always keep the center of
gravity within the footprint of the leveling feet. To further secure larger arrays – particularly in outdoor
situations – use tie down straps or extra ballast weight on the MG-3D/M grid.
CAUTION: For safety
reasons, ground-supported
arrays of more than six MILO
loudspeakers using the MG-3D/M
grid should be avoided. Larger
stacks can be unstable, especially
in windy conditions and on uneven
ground.