Meyer Sound MG-3D/M Model Vehicle User Manual


  Open as PDF
of 32
 
MG-3D/M MULTIPURPOSE GRID AND ACCESSORIES
PN: 05.132.036.01 B2
Page 12 of 32
Meyer Sound Laboratories Inc.
www.meyersound.com
T: +1 510 486.1166
F: +1 510 486.8356
MLK-MILO LINK KIT
The MLK-MILO link kit is required to attach a MILO loudspeaker to the MG-3D/M multipurpose grid.
In flown configurations, the first MILO loudspeaker in the array is always connected to the MG-3D/M grid at 0°. In
ground-supported configurations, the first MILO loudspeaker in the array can have from –1° to 4° in relation to the
MG-3D/M grid. In both flown and ground-supported configurations, MILO loudspeakers in an array may be
individually splayed at nine different tilt angles from 0° to 5° (0°, .5°, 1°, 1.5°, 2°, 2.5°, 3°, 4°, 5°), through the selection
of the pin positions in accordance with your system design. Labels on the MG-3D/M grid show the correct orientation
of the MG-3D/M grid for a flown or ground-supported configuration, and the front and rear positions for both MILO
and M3D/M3D-Sub loudspeakers. In addition, please note that:
 The orientation of the MG-3D/M grid for a ground-supported configuration is a 180° (flipped) rotation from the
flown position.
 For MILO loudspeakers, the front side of the MG-3D/M grid is opposite the side used for flying M3D/M3D-Subs.
NOTE: Do not confuse the 3/8" x 1.5" QRPs included with the MLK-MILO link kit with the standard
QRPs used for connecting MILO loudspeakers to each other. The standard MILO end frame QRPs are
shorter and will not lock properly. In addition to being longer, the MLK-MILO kit’s QRPs are distinguished by a
red release button (standard MILO QRPs are blue or black), and include a lanyard for securing each pin to the
MG-3D/M grid (via small screw holes on the inside of the grid). By permanently affixing the QRPs to the
MG-3D/M grid using the lanyards, you can ensure that the correct QRPs are always used.
NOTE: The MFAL-MILO front and MRAL-MILO rear AlignaLinks are the same ones used between
individual MILO cabinets in a MILO array. Always use all three pins in the triangular front AlignaLink,
just as you would when connecting MILO cabinets together.
List of Contents: MLK-MILO Link Kit (Part 40.132.125.01)
Required for use with MILO loudspeaker(s)
Qty Part Number Description
2 61.132.027.03 MFAL-MILO Front AlignaLink
2 61.132.028.01 MRAL-MILO Rear AlignaLink
6
134.023
3/8" x 1.5" Quick Release Pin (QRP)*
*Includes lanyard and necessary hardware
to fix the pin to the MG-3D/M
 previous next