Support User Manuals

Invacare Adjustable ASBA Seat Car Seat User Manual

Open as PDF

of 76

SECTION 10—JUNIOR BACKS

Part No 1143238 55 Adjustable ASBA Seat

SECTION 10—JUNIOR BACKS

ƽ WARNING

After any adjustments, repair or service and before use, make sure all attaching

hardware is tightened securely - otherwise injury or damage may result.

Before performing any maintenance, adjustments or service, ALWAYS turn the

wheelchair power off, otherwise injury or damage may result.

Adjusting the Back Width

Anewbackpanisrequiredwhenthebackwidthisadjusted.BackwidthMUSTbe

adjustedwithseatwidth.RefertoAdjustingtheSeatWidthonpage 72.

Adjusting the Back Angle

ƽ WARNING

Wheelchairs with TRRO Only - Adjusting the back angle from the factory setting

will void TRRO compliance. After adjusting the back angle, DO NOT transport an

occupied wheelchair in a motor vehicle of any kind. The wheelchair may only be

transported in a motor vehicle while unoccupied, and will be considered TRBKTS.

NOTE:Forthisprocedure,refertoFIGURE 10.1onpage 56.

1. Loosen,butDONOTremove,thetwolowermountingscrewssecuringthecane

bracketstothebackcanesandinserts.

2. Removethetwouppermountingscrews,washers*,twocovedwashersandtwo

locknutssecuringthecanebracketstothebackcanesandinserts.

*NOTE:Non‐TRROwheelchairshavefourwashersandTRROwheelchairshavetwowashers.

3. Aligntheuppermountingholesinthebackcanesandinsertswiththedesired

mountingholesinthecanebrackets(Detail“A ” ) .

4. Installthetwouppermountingscrews,washers*,covedwashersandlocknutsto

securethecanebracketstothebackcanes.

5. Torquethelocknutsonupperandlowermountingscrewsto156in‐lbs±20%.

previous next