Support User Manuals

Invacare Adjustable ASBA Seat Car Seat User Manual

Open as PDF

of 76

SECTION 9—ADULT BACKS

Adjustable ASBA Seat 50 Part No 1143238

Adjusting the Back Width

Anewbackpanisrequiredwhenthebackwidthisadjusted.BackwidthMUSTbe

adjustedwithseatwidth.RefertoAdjustingtheSeatWidthonpage 62.

ContouraBacksOnly‐Seatandbackwidthsarerestrictedto16,18,20,22or24inches.

Adjusting the Back Angle

ƽ WARNING

Wheelchairs with TRRO Only - Adjusting the back angle from the factory setting

will void TRRO compliance. After adjusting the back angle, DO NOT transport an

occupied wheelchair in a motor vehicle of any kind. The wheelchair may only be

transported in a motor vehicle while unoccupied, and will be considered TRBKTS.

NOTE:Forthisprocedure,refertoFIGURE 9.2.

1. Loosen,butDONOTremove,thetwolowerhexscrewssecuringthecanebracketsto

thebackcanes.

2. Removethetwoupperhexscrews,washersandlocknutssecuringthecanebrackets

tothebackcanes.

3. Aligntheuppermountingholesinthebackcanes

withthedesiredmountingholesin

thecanebrackets(Detail“A”).

4. Installthetwoupperhexscrews,washersandlocknutstosecurethecanebracketsto

thebackcanes.

5. Torquethelocknutsonupperandlowerhexscrewsto13ft‐lbs±20%.

FIGURE 9.2 Adjusting the Back Angle

Cane Bracket

Back Cane

Upper Hex

Screw

Lower Hex

Screw

Washer

Locknut

105°

100°

90°

95°

DETAIL “A” - CANE

BRACKET

MOUNTING HOLES

85°

previous next