Support User Manuals

Invacare Adjustable ASBA Seat Car Seat User Manual

Open as PDF

of 76

SECTION 9—ADULT BACKS

Adjustable ASBA Seat 48 Part No 1143238

SECTION 9—ADULT BACKS

ƽ WARNING

After any adjustments, repair or service and before use, make sure all attaching

hardware is tightened securely - otherwise injury or damage may result.

Before performing any maintenance, adjustments or service, ALWAYS turn the

wheelchair power off, otherwise injury or damage may result.

Removing/Installing the Contoura Back

NOTE:Forthisprocedure,refertoFIGURE 9.1onpage 49.

Removing the Contoura Back

1. Removebackcushion.

2. Removethetwomountingscrewsthatsecurethelowerfrontmountingbracketstothe

backcanes.

3. Removethefoursocketscrews,washersandlocknuts(notshown)thatsecurethefour

frontandrearmountingbrackets.

4. RemovetheContourabackandhardwarefromthebackcanes.

Installing the Contoura Back

1. Positionthefrontmountingbracketsagainstthebackcanes.

2. Securethelowerfrontmountingbracketstothebackcanesusingthetwomounting

screws.Torqueto32in‐lbs±20%.

3. Insertthetaboftherearmountingbracketintotheslotinthefrontmountingbracket.

4. Securethefourrearmounting

bracketstothefourfrontmountingbracketsusingthe

foursocketscrews,washersandlocknuts(notshown).Torqueto75in‐lbs±20%.

5. Ifnecessary,tightenthesocketscrewsandlocknutssecuringthefrontmounting

bracketstotheslotintheContouraback.Torqueto75in‐lbs±20%.

Removing the Mounting Hardware from the Contoura Back

1. Removethefoursocketscrews,eightwashersandfourlocknutsthatsecurethefront

mountingbrackettotheContouraback.

2. Removethehardwarefromtheback.

previous next