Filter
Top Products
1
Steering Linkage
Front Axle
Front Axle
Vehicle Body
Fork
Axle/Linkage
Assembly
Steering
Linkage
Rivet Head
U-Clip #1
Peg
Slot
Tab
Base
Base Platform #1
Front Axle
Short Leg
Long Leg
Pivot
Groove
Do Not Omit Any Steps
Assembly
3
F
9
2
1
• Using safety scissors, separate the U-clips from the
plastic connector. Dispose of the plastic connector.
• The U-clips and base platforms are marked with a
“1” or a “2”. Note the markings on the U-clips and
base platforms.
• Snap the tab on U-clip #1 into the slot in base
platform #1.
• Insert a #8 x 1" screw through the U-clip and into the
base platform.
• Tighten the screw with a Phillips screwdriver. Do not
over-tighten.
• Repeat this procedure to assemble U-clip #2 to base
platform #2.
• Position the steering linkage with the two rivet heads
facing up.
• Insert the short leg of a front axle up through the hole in
the pivot at one end of the steering linkage. Make sure
the axle’s long leg fits into the groove in the bottom of
the pivot.
Helpful Hint: You may need to tap the front axle with a
hammer to fit the long leg in the groove.
• Repeat this procedure to fit the remaining front axle
to the steering linkage.
• Fit a collar, solid end first, onto the short leg of a
front axle.
• Fit a cap nut onto the end of the axle's short leg.
• Tap the cap nut with a hammer to secure it on the end of
the front axle.
• Repeat this procedure to assemble the remaining collar
and cap nut to the other front axle.
4
Cap Nut
Collar
Front Axle
Short Leg
Steering Linkage
• Turn the vehicle body upside down.
• Fit the collars on the steering linkage assembly onto the
fork on the vehicle body as shown. Make sure the front
axles are towards the front of the vehicle and the
steering linkage is toward the rear of the vehicle.