Filter
Top Products
21
Attaching Your Vehicle to the Base
Removing Your Vehicle from the Base
K
Attaching Your Vehicle to the Base
1
FREEWHEEL
MOTORIZED
FREEW
HEEL
M
O
TORIZED
Push Here
Selector
Lever
Selector Lever
Handlebar
Button
• To assemble the vehicle to the base, the vehicle should
be set to the MOTORIZED position. Press the handlebar
button to make sure the vehicle is set to MOTORIZED. If
the vehicle does not move forward when the handlebar
button is pushed, it is set to FREEWHEEL.
• To switch the vehicle from FREEWHEEL to MOTOR-
IZED, unlock and remove the seat. Press the handlebar
button and at the same time switch the selector lever to
the MOTORIZED position.
• Place the base on the floor.
• Turn the vehicle’s rear wheels to position the cam tabs
down, as shown. (See inset.)
• Position the vehicle over the base so that the rear
wheels are above the U-clips.
• Pull out to spread the rear wheels and lower the vehi-
cle on the base so that the cam tabs rest on the
U-clips as shown in illustration 2.
Rear Wheels
Pull Wheel Out
Cam
Tab
Down
Cam
Tab
U-Clip
Base
Inset
2