Filter
Top Products
Battery Installation
16
Important Note: Use only a Power Wheels
®
6 volt
(4 Amp/hr.) battery with a Power Wheels
®
25 amp fuse
installed. Use of any other battery or fuse will damage
your vehicle. Make sure that you charge the battery for at
least 18 hours using the enclosed Power Wheels
®
6 volt
charger before operating your vehicle for the first time.
Charge the battery for at least 18 hours after each use of
the vehicle. Never charge the battery longer than 30 hours.
Failure to follow these instructions may damage your bat-
tery and will void your warranty.
1
H
• Position the battery retainer over the battery with the
ends of the battery retainer aligned with the screw holes
in the vehicle body.
• Insert two #8 x
7
/8" screws through the ends of the bat-
tery retainer and into the vehicle body.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
2
• Fit the battery into the protective foam battery pocket.
• Place the battery upright in the battery compartment.
Do
not place the battery in the battery compartment
without the protective foam pocket. Make sure the
battery connector extends toward the rear of the vehicle.
• Make sure a Power Wheels
®
25 amp fuse in good
condition is installed in the battery.
Battery
25 Amp
Fuse
Protective
Foam Pocket
Battery
Connector