Filter
Top Products
Rectangular
Opening
Handlebar
Button End
Connector
End
Handlebar
Wire Harness
Handgrip
Handgrip
Handlebar
• Insert two #10 x
3
/
4
" screws through the slots in the
headlight and into the pegs in the handlebar.
• Press firmly on the front of the headlight and tighten
each screw with a Phillips screwdriver. Make sure there
is no gap between the headlight and the handlebar.
• Snap the knobs and key assembly into the handlebar
console.
• Bend the end of the microphone cord so that it forms
a "T".
• Insert the end of the microphone cord through the small
hole in the handlebar console.
• Fit the tab on the back of the microphone into the slot in
the handlebar console.
10
9
Assembly
• Fit a handgrip onto each end of the handlebar.
Helpful Hint: If the handgrips are difficult to slide onto the
handlebar, moisten the handgrips with warm water before
fitting them onto the handlebar.
11
11
12
Handlebar
Console
Slot
Key Assembly
Microphone
Knobs
T-End
Microphone
Cord
Press Here
• Insert the connector end of the handlebar wire harness
into the rectangular opening in the handlebar.
• Feed the handlebar wire harness through the handlebar.
• Push firmly on the button end of the handlebar wire har-
ness to snap it into the rectangular opening.