Filter
Top Products
22
Attaching Your Vehicle to the Base
Removing Your Vehicle from the Base
Removing Your Vehicle from the Base
Fenders
Base
• Place both feet on the base to hold it in place.
• Grip the vehicle fenders.
• Pull up firmly to release the rear wheel drivers from the
U-clips.
• Slide the vehicle back slightly to release the T-slider from
the slot and remove the vehicle from the base.
• Set the base aside. Your vehicle is ready for foot-to-floor
freewheeling use, or for use as a battery-powered
ride-on vehicle.
STEP
HERE
PULL HERE
• Position your knee on the vehicle seat and lean firmly on
the seat.
• While pushing down firmly on the vehicle seat, press
the power button to rotate the rear wheels and seat
the cam drivers in the U-clips. You will feel and hear
• Push the vehicle forward slightly to engage the t-slider in
the slot on the base. (The t-slider is on the underside of
the vehicle.) The cam tabs should now be directly above
the “U” portion of the U-clips.
“U” Portion of
U-Clip
No Gap
Cam Tab
PRESS HERE
3
4
PUSH DOWN HERE
the cam drivers pop into the U-clips. There should be no
gap between the cam drivers and the U-clips.
• To make sure the vehicle is properly secured to the
base, lift the vehicle. If the front or the rear wheels lift
away from the base, the vehicle is not properly attached
to the base. Repeat the above procedure to attach the
vehicle to the base.
• With the vehicle properly attached to the base, it is ready
for use as a battery powered rocking kiddie-ride.