Filter
Top Products
22
23
• Align the holes in a footrest with the holes in one end of
the footrest support bar.
• Insert a #10 x 1
1
/
4
" bolt through the footrest and footrest
support bar.
• Fit a lock nut onto the end of the bolt and hand-
tighten it.
• Turn the vehicle body on its side.
• Using a Phillips screwdriver to steady the screw and
pliers to grip the lock nut, continue to tighten the bolt and
lock nut on each footrest.
• Turn the vehicle body upright.
One time assembly is now complete. Do not assemble
the seat until after you have charged and installed
the battery in the vehicle. Please refer to the Battery
Installation section beginning on page 16 for
instructions.
14
21
Please Note: If you have not removed the protective foam
pocket from the battery compartment, please remove it
and set it aside for later use. Remove any excess tape
from the vehicle and protective foam pocket and discard of
the tape properly.
• Stand the vehicle body on its rear wheels.
• Align the holes in the T-slider with the holes in the
underside of the vehicle body, directly under the battery
compartment.
• Insert three #8 x
1
/
2
" screws through the floor of the bat-
tery compartment and into the T-slider.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Position the vehicle body upright.
Assembly
Holes
Hole
Footrest
Footrest
Support Bar
Grooves
Footrest
Support
Footrest
Support
Bar
Footrest
• Insert the footrest support bar through the footrest
support at the bottom of the vehicle body. Make sure the
grooves on the footrest face up.
• Align the holes in the other footrest with the holes on the
other side of the footrest support and repeat assembly
step 22 on the other side of the footrest support.
T-Slider
Footrest
24