Filter
Top Products
EN-72
Configuring Digital Piano Settings
Chorus Edit
Chorus Type Selects the chorus type. Chorus1, Chorus2, Chorus3,
Chorus4, FB Chorus, Flanger1,
Flanger2, Flanger3, Flanger4,
Short Delay1, Short Delay2,
Short Delay3, Short Delay4,
Soft Chorus, Bright Chorus,
Deep Chorus
LFO Rate Adjusts the LFO rate. 0 to 127
LFO Depth Adjusts the LFO depth. 0 to 127
Feedback Adjusts the feedback amount. 0 to 127
Tone Adjusts the tone. 0 to 127
Delay Time Adjusts the delay time. 0 to 127
Delay Send Adjusts the send level to system delay. 0 to 127
Reverb Send Adjusts the send level to system reverb. 0 to 127
Return Adjusts the return level. 0 to 127
Delay Edit
Delay Type Selects the delay type. Short 1, Short 2, Echo,
Short Tempo, Mid Tempo,
Long Tempo
Time Adjusts the total delay time. 0 to 127
Feedback Adjusts the feedback amount of the center channel. 0 to 127
High Damp Adjusts the high-range damp. A smaller number increases
damping.
0 to 127
Ratio L Adjusts the ratio of the left channel relative to the total delay
time.
0 to 127
Ratio C Adjusts the ratio of the center channel relative to the total
delay time.
0 to 127
Ratio R Adjusts the ratio of the right channel relative to the total delay
time.
0 to 127
Level L Adjusts the level of the left channel. 0 to 127
Level C Adjusts the level of the center channel. 0 to 127
Level R Adjusts the level of the right channel. 0 to 127
Tempo Sync Specifies how the actual total delay time is synced with tempo.
Off: Uses Delay Time value.
1/4 to 2: Uses value in accordance with number of beats.
Off, 1/4, 1/3, 3/8, 1/2, 2/3, 3/4,
1, 4/3, 3/2, 2
Reverb Send Adjust the send level to system reverb. 0 to 127
Return Adjusts the return level. 0 to 127
Master Comp Edit
Threshold Adjusts the threshold (where application of an effect starts)
level. Set a lower value for a compressor effect, and a higher
value for a limiter effect.
0 to 127
Ratio Adjusts the compression ratio. Set a lower value to for a
compressor effect, and the maximum value to for a limiter
effect.
0 to 127
Level Adjusts the output level. 0 to 127
Attack Adjusts the time until the compression effect starts. A smaller
value causes prompt compressor operation, which suppresses
the attack of the input signal. A larger values delays
compressor operation, which causes the attack of the input
signal to be output as-is.
0 to 127
Item Description Setting
PX560-ES-1A.indd 74 2015/06/18 14:53:53