Filter
Top Products
11
INSTALLING THE HDSWG 1000 CONTROL BOX
The HDSWG 1000 CONTROL BOX may be mounted remotely
from the MECHANICAL UNIT. Four mounting holes are
provided at the back of the CONTROL BOX. These should be
used to mount the CONTROL BOX to a solid, flat surface. Use
a caulking material around the holes to ensure a water tight seal.
The CONTROL BOX should be located so that the Gate and the
MECHANICAL UNIT/UNITS ARE IN FULL VIEW FROM
THE CONTROL BOX.
ELECTRICAL HOOK UP
The HDSWG 1000 electrical connection is made at the electrical
junction box provided in the HDSWG 1000 CONTROL BOX, see
Figure 11. There are three cutouts on the bottom of the CONTROL
BOX to permit conduit entry. Run a flexible water tight conduit
from the service junction box to the access hole that is just under the
junction box containing the main power switch of the HDSWG 1000.
Pull three #14 wires from the service junction box to the junction box
inside the HDSWG 1000 Control Box. If the HDSWG 1000 is wired
for 115 Volts, pull a black, white and green wire. If the HDSWG
1000 is wired for 230 Volts, pull a black, red and green wire.
TO AVOID ELECTRICAL DAMAGE TO OPERATOR
DO NOT ALLOW TOTAL WIRE LENGTH FROM THE
CONTROL BOX TO AC POWER SERVICE PANEL
PLUS
THE DISTANCE FROM THE CONTROL BOX
TO THE MECHANICAL UNIT TO EXCEED WIRE
LENGTH GIVEN IN TABLE 1 FOR AC SERVICE.
WARNING!
WARNING!
RISK OF ENTRAPMENT.
TO MINIMIZE POTENTIAL FOR GATE CONTROLS
TO BE ACTIVATED WHILE ALREADY IN USE,
LOCATE THE HDSWG 1000 CONTROL BOX IN
FULL VIEW OF THE GATE.
Figure 11: Schematic & Wiring Diagram
105100
C:
INSTALLING THE OPERATOR