Filter
Top Products
Overview
42 QuadraSynth Reference Manual
To audition Programs before overwriting them with STORE
Éwhen editing a Program in Mix mode:
➀ While in Mix Program Edit mode, press [PROGRAM].
This selects Program mode, but retains your changes to the Program in Mix Edit.
➁ Turn Quad Knob [3] to the right so that ÒPROGRAM TYPE: USERÓ appears on
the top line of the display.
➂ Use Quad Knob [1] to scroll through the Programs until you find one you wish to
overwrite with the new edited program. Take a note of the number.
➃ Press [MIX].
This recalls the edit buffer in Mix mode, which contains your edited Program.
➄ Press [SELECT] twice, until ÒEDITING: PROGRAMÓ appears under the MIX
number in the display.
➅ Press [STORE].
The top line of the display will read ÒSTORE PRG AT XXX?Ó where XXX is a User
Program number from 000Ñ127.
➆ Use Quad Knob [1] to enter the Program number you noted in step 3.
➇ Press [STORE] again.
The Program is now stored.
At this point your edited Program is stored, however the Mix your were auditioning
before storing the Program still has the old Program number assigned (if the edited
Program was saved to a different Program number location). Therefore, you need to
re-select the new Program number from within Mix Edit mode.
➈ Press [MIX], then [SELECT] to access Mix Edit mode.
➉ Use the MIDI [¬] and [®] buttons to select the MIDI channel you want, and use
the VALUE [-] and [¯] buttons or Quad Knob [1] to select the Program number.