Filter
Top Products
Your First Session with the QuadraSynth
QuadraSynth Reference Manual 19
Auditioning Effects
Each Program and Mix uses one of the 256 Effects Patches to enhance the sound. You
select which Effect you wish to use from Program Edit or Mix Edit mode. While the
Program remembers which Effect Patch to use, and how much sound to send to it
(and to which of the four effects buses), all Effects Patch editing is done outside of the
Program in Effects Edit Mode (see Chapter 6).
In a Mix, you can combine several Programs, and use one of the Effects Patches. All
the Programs can use this one Effects Patch (or bypass it). Also, each Program in the
Mix can either retain its own effects settings (send level and bus), or you can override
and reroute them with the Mix Mode effects settings. In this section, we will audition
the various preset Effects patches from PROGRAM mode.
➀ Press [PROGRAM] and select a Program using the VALUE [¯] and [-] buttons.
The display will change to Program Mode.
➁ Press [SELECT].
The display will change to Program Edit mode. The last function and page selected will
be shown in the display. To get back to the first function, simultaneously press both
FUNCTION [¬] and [® ].
➂ Press FUNCTION [®] eight times, or until the word ÒEFFECTÓ is underlined.
MIDI
CHAN
PROG
1
EFFECT
PRESET PRESET
EDITING: PROGRAM SOUND 1
PAGE:
1
"Ch
®
Dly
®
Rev1"
NUMBER TYPE
PITCH FILTER AMP RANGE MOD EFFECT NAME
PLFO FLFO ALFO PENV FENV AENV TRACK
MISC.
ASSIGN – VOICE LEVEL EFFECT–LEVEL
➃ Use Quad Knob [1] to select an Effect Patch from 00Ñ127.
The display will change to indicate the currently selected EffectÕs number and name.
Changes to Program parameters are temporary and will be lost if another Program is selected.
To make changes permanent, you must store the Program into the User bank. Refer to
Chapter 4 for information about storing changes.
✪