Filter
Top Products
Editing Effects
100 QuadraSynth Reference Manual
Input level
Quad Knob [4] controls the overall Input Level going into the Reverb.
Chorus Input Level
If Configuration #2 is selected (refer to block diagram of Configuration #2, earlier in
this chapter), the first page of the Reverb function will look like this:
PROG EFFECT
PRESET
EDITING: EFFECT
PITCH MOD NAME
CONFIG
REVERB DELAY MIX
PAGE:
1
CHORUS IN LEV: 00
CHORUS-IN
PRESET
MIDI
CHAN
MIX
PRESET
12345678910111213141516
234
1
The Configuration has two Reverbs, one on send 1 (which send 2 can share), the
other on send 3 (which send 4 can share). There is only one parameter in this page:
Chorus Input Level. Quad Knob [1] lets you adjust the level of the signal coming
from the Pitch output going into the Reverb, otherwise the signal comes purely from
the Pitch input.
The other parameters and pages in the Reverb function are identical, regardless of
which Configuration is being used. Only page 1 is different, because of the fewer
input choices the Reverb has in this Configuration.
Send Input Levels
If Configuration #1 is selected and you press [EDIT 1] to advance to effect send 2, the
display will now show you the parameters that represent the signal levels on send 2
going into the Reverb. Note that there is now only 1 page available, since the other
reverb parameters are found back on effect send 1.
Press [EDIT 1] again to advance to send 3, and the display will still look the same, but
now the parameters adjust the signal levels on send 3 going into the Reverb. If you
press [EDIT 1] again and advance to send 4, the display will look like this:
PROG EFFECT
PRESET
EDITING: EFFECT
PITCH MOD NAME
CONFIG
REVERB DELAY MIX
PAGE:
1
BAL: SEND4<00>DEL
BALANCE LEVEL
PRESET
MIDI
CHAN
MIX
PRESET
12345678910111213141516
4
There are only two parameters: Balance and Input Level. This is because in
Configuration #1, effect send 4 only has a Delay effect, and not a Pitch effect like the
other effect sends do. Quad Knob [1] controls the Balance between the Delay output
and the dry effect send signal, while Quad Knob [3] controls the overall input level to
the Reverb.