Filter
Top Products
Your First Session with the QuadraSynth
20 QuadraSynth Reference Manual
Setting the Effects Level
Each Program can use up to four sounds, for either layering or splitting the
keyboard. Each of these sounds has its own effects , as well as effects bus assignment.
Many of the Programs in the QuadraSynth use only one or two sound layers, while
others may use all four sounds. You can adjust the effect send amount for each sound
independently, or you can view/edit all four sounds simultaneously.
➀ While still in Program Edit mode, press the FUNCTION [¬] button six times
(from the ÒEFFECTÓ Function), or until the words ÒEFFECT - LEVELÓ are
underlined in the display.
This is where you determine how much level will be sent from the current Program
sound layer to the effects processor, and on which of the four busses.
MIDI
CHAN
PROG
1
EFFECT
PRESET PRESET
EDITING: PROGRAM SOUND 1
PAGE:
1
EFFECT LEVEL: 99
LEVEL BUSS
PITCH FILTER AMP RANGE MOD EFFECT NAME
PLFO FLFO ALFO PENV FENV AENV TRACK
MISC.
ASSIGN – VOICE LEVEL
EFFECT–LEVEL
➁ Turn Quad Knob [1] to adjust the effect send level of the selected sound (1Ñ4).
For the most dramatic effect, set this to 99.
➂ Press the [EDIT 1] button to select another sound to adjust.
The display will indicate ÒSOUND 1Ó or ÒSOUND 2,Ó etc., to indicate which of the
four sounds is being edited.
➃ Press the [EDIT 4] button to display the effect send levels of all four sounds
simultaneously; use Quad Knobs [1] Ñ [4] to adjust each soundÕs effect level.
The display will indicate ÒSOUND 1 2 3 4.Ó
MIDI
CHAN
PROG
1
EFFECT
PRESET PRESET
EDITING: PROGRAM SOUND 1
PAGE:
1
EFFECT LEVEL: 99
SND1 SND2 SND3 SND4
PITCH FILTER AMP RANGE MOD EFFECT NAME
PLFO FLFO ALFO PENV FENV AENV TRACK
MISC.
ASSIGN – VOICE LEVEL
EFFECT–LEVEL
234
2
Note: If a sound is not enabled in a Program, its title will be shown in lowercase (Òsnd4Ó),
and turning that control will have no effect on the sound until the sound is enabled. To enable
a sound, hold down its respective Quad Button (i.e., [3] for Sound #3) and press VALUE
[-].