xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
Methods
None – Specifies that multiple authentication is not enabled.
Any – Specifies that a client will gain access if it passes any of the authentication methods
(802.1X, MAC, or JWAC).
802.1X+IMPB – Specifies that 802.1X+IMPB can be enabled on a port at the same time.
802.1X will be verified first, and then IMPB will be verified. Both authentication methods need
to be passed. If either authentication method fails, the client will be denied access.
IMPB+JWAC – Specifies that JWAC and IMPB can be enabled on a port at the same time.
JWAC will be verified first, and then IMPB will be verified. Both authentication methods need to
be passed. If either authentication method fails, the client will be denied access.
VID List
Enter a list of VLAN IDs.
State
Use the pull-down menu to enable or disable this function.
Click Apply to implement changes made.
Authentication Guest VLAN Settings
This window is used to display and configure the Authentication Guest VLAN settings on the Switch.
To view this window, click Security > Compound Authentication > Compound Authentication Guest VLAN Settings, as
shown below:
Figure 7- 76. Authentication Guest VLAN Table window
To configure a new entry click the Add button, to reveal the following window:
Figure 7- 77. Authentication Guest VLAN Settings - Add window
The following parameters may be set:
Parameter Description
VID / VLAN Name
Select either VID or VLAN Name and enter the appropriate information about a previously
configured VLAN.
Port List (e.g.:1,6-9)
Enter the port or list of ports you wish to configure. Check the Select All Ports check box to
select all ports.
Action
Select the action you wish to apply to the Guest VLAN.
Select Add to add a port to the Guest VLAN portlist or Delete to remove ports from the Guest
VLAN portlist.
Click Apply to implement changes made.
407
