xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
Figure 7- 9. IMPB Global Settings window
The following parameters can be set:
Parameter Description
Trap / Log
This field will enable and disable the sending of trap log messages for IP-MAC binding. When
Enabled, the Switch will send a trap log message to the SNMP agent and the Switch log
when address binding module detects illegal IP and MAC addresses.
DHCP Snoop (IPv4)
Use the pull-down menu to enable or disable the DHCP snooping state (IPv4) for IP-MAC-
port binding.
DHCP Snoop (IPv6)
Use the pull-down menu to enable or disable the DHCP snooping state (IPv6) for IP-MAC-
port binding.
ND Snoop
Use the pull-down menu to enable or disable the ND snooping state for IP-MAC-port binding.
Click Apply to implement the settings made.
IMPB Port Settings
This window is used to configure IMP settings on a port basis.
Select a port or a range of ports with the From Port and To Port fields. Enable or disable the port with Strict or Loose State, enable
or disable Allow Zero IP and Forward DHCP Packet fields, and configure the port’s Max IMPB entry.
To view this window click, Security > IP-MAC-Port Binding > IMPB Port Settings, as shown below:
351
