CALIBRATION AND SETUP, CONT.
Using the numeric keys, enter the value for the new backlight turn-on level and then press
ve the new setting and return to SETUP MENU #3. Allowable values
e selected must be less than the Lights= value to activate.
BACK LITE=0 B BACK LITE=XX
Ba light always OFF Level that backlight
turns ON at
PASSWORD
3. PASSWORD
The password setup parameter determines whether a password is required to enter
ernational use (USA=NO). If the
ILL NOT
ey and then the ENTER key. The display
the
ill
If the se roceed to erwise,
using the alpha-numeric keys, enter up to 12 characters for the password and then press
the ENTER
the ENTER key to sa
are: 0 through 99.
NOTE! The valu
ACK LITE=99
cklight always ON Back
(PASSWORD)
Calibration and Setup on indicators programmed for int
indicator is programmed for domestic use (USA=YES) the password parameter W
be displayed on SETUP MENU #3.
ith the SETUP MENU #3 displayed press the 3 kW
will change to show PASSWORD=XXXXXXXXXXXX. Note that XXXXXXXXXXXX is
current password if a password was previously entered, otherwise only PASSWORD= w
be d splayed. i
tting displayed is acceptable, p the next setup parameter. Oth
key to save the new setting and return to the SETUP MENU #3.
PASSWORD OPERATION
ith a PASSWORD set, anytime the operator tries to enter Calibration and Setup, the
isplay will show the PASSWORD= prompt requiring the operator to enter the correct
entered the indicator displays
W
d
password. If the wrong password is ERROR momentarily
a
t
NOTE! It is recommended to write t
Usecure
nd returns to the weight mode. Note that the password is not shown on the display when
he operator is entering it.
he password down and store it in a U
lo ation. If the password a change to the indicator setup
is required, the indicator must be reprogrammed. WARNING! Reprogramming
the indicator will ERASE ALL
c is forgotten or lost and
the contents of the Nov-Ram and memory.
8200-M538-O1 y 225 Installation
Page 73
