CALIBRATION AND SETUP, CONT.
5. CONT=XXX (PRINTER CONTINUOUS OUTPUT)
With the PRINTER SETUP MENU displayed the current setting for the CONT=
parameter will be shown. Note that XXX is the current value. If the setting displayed
acceptable, proceed to the next setup parameter.
is
CONT=YES CONT=NO
uous Output Enabled s Outpu
6. XXXXX RINTER
With the PRINTER SETUP MENU display t settin for the TYPE=
p will be sho at X is t lue and XXXXXXXXXX is the
description. If the setting displayed is acceptable, proceed to the next setup parameter.
the
s are 0
rough 7 and 9.
2 = SB200 6 = SB500
INTER DATA)
turn to the Serial Menu.
IR ON=YES IR ON=NO
IR Data Port is Enabled and IR
input is allowed.
IR Data Port is Disabled and IR
input will be ignored.
Otherwise, press the 5 key, the ENTER key, YES or NO (on the soft keys) and then the
ENTER key to save the new setting and return to the PRINTER SETUP MENU.
Contin Continuou t Disabled
TYPE=X XXXXX (P CONTINUOUS OUTPUT SELECTION)
ed the curren g
arameter wn. Note th he current va
Otherwise, press the 6 key, the ENTER key and then using the numeric keys, enter
value for the printer continuous output selection and then press the ENTER key to save
the new setting and return to the PRINTER SETUP MENU. Allowable value
th
0 = SMA 4 = TOL SHORT 9 = TALLEY
1 = SB400 5 = NUMERIC WT
3 = IQ355 7 = SB250/500M
7. SCALE=X (SCALE USED FOR PR
With the PRINTER SETUP MENU displayed the current setting for the SCALE=
parameter will be shown. Note that X is the current value. If the setting displayed is
acceptable, proceed to the next setup parameter.
Otherwise, press the 7 key, the ENTER key and then using the numeric keys, enter the
value for the scale the printer will receive data from and then press the ENTER key to
save the new setting and return to the PRINTER SETUP MENU. Allowable values are
through 4. NOTE! Scale 1 is the default setting. Also note, 4 is the Scale Totalizer. 1
8. IR ON=XXX (INFRARED “IR” DATA PORT)
With the PRINTER SETUP MENU displayed the current setting for the IR ON=
parameter will be shown. Note that XXX is the current value. If the setting displayed is
cceptable, press EXIT (Navigation Keys UP Arrow) to rea
Otherwise, press the 8 key, the ENTER key, YES or NO (on the soft keys) and then the
ENTER key to save the new setting and return to the PRINTER SETUP MENU.
8200-M538-O1 y 225 Installation
Page 42
