![](https://pdfstore-manualsonline.prod.a.ki/pdfasset/2/94/294afa79-af6a-4ace-9936-39e8dc142036/294afa79-af6a-4ace-9936-39e8dc142036-bg32.png)
CALIBRATION AND SETUP, CONT.
6. TYPE=X XXXXXXXXXX (COM1 CONTINUOUS OUTPUT SELECTION)
meter
s are 0 through
and 9.
0 = SMA 4 = TOL SHORT 9 = TALLEY
UMERIC WT
7. SCALE=X (SCALE USED FOR COM1 DATA)
Otherwise, press the 7 key, the ENTER key and then using the numeric keys, enter the
ceive data from and then press the ENTER key to
are 1
NOTE! If you selected 6. SB500 for the TYPE= parameter, the following
)
lue. If the
ation Keys UP Arrow) to return to
e Serial Menu.
d then the
NTER key to save the new setting and return to the COM 1 SETUP MENU.
Ma Ma
Manual Mode is Enabled. Pressing
START/STOP key will toggle traffic
light between Green and Red.
Manual Mode is Disabled.
Threshold weight is used to toggle
light between Green and Red.
With the COM1 SETUP MENU displayed the current setting for the TYPE= para
will be shown. Note that X is the current value and XXXXXXXXXX is the description. If
the setting displayed is acceptable, proceed to the next setup parameter.
Otherwise, press the 6 key, the ENTER key and then using the numeric keys, enter the
value for the printer continuous output selection and then press the ENTER key to save
the new setting and return to the COM1 SETUP MENU. Allowable value
7
1 = SB400 5 = N
2 = SB200 6 = SB500
3 = IQ355 7 = SB250/500M
With the COM1 SETUP MENU displayed the current setting for the SCALE=
parameter will be shown. Note that X is the current value. If the setting displayed is
acceptable, proceed to the next setup parameter.
value for the scale the printer will re
save the new setting and return to the COM1 SETUP MENU. Allowable values
through 4. NOTE! Scale 1 is the default setting. Also note, 4 is the Scale Totalizer.
setup parameters Manual Mode= and Thres Wt=will be shown on the
COM 1 SETUP MENU.
9. Manual Mode=XX (MANUAL LIGHT MODE
With the COM 1 SETUP MENU displayed the current setting for the
Manual Mode= parameter will be shown. Note that XXX is the current va
setting displayed is acceptable, press EXIT (Navig
th
Otherwise, press the 9 key, the ENTER key, YES or NO (on the soft keys) an
E
nual Mode=YES nual Mode=NO
8200-M538-O1 y 225 Installation
Page 46