Filter
Top Products
21
reface CS/DX/CP/YC Owner’s Manual
Functions of Front Panel Components
DX
i[FUNCTION] button
When pressed, the button’s lamp lights up and
Function mode is activated. In this condition,
the button can be pressed repeatedly to cycle
through the mode’s individual pages. When
you press a different button, the lamp goes out
and the instrument leaves Function mode. In
Function mode, you can set Voice Parameter,
MIDI, System, and Job parameters.
Page 1: Voice Parameter Settings
screen
For setting the way sounds are produced for
each Voice.
Whenever you store a Voice by using the
[STORE] button, Voice parameter settings
are stored.
Page 2: MIDI Settings screen
TP
(Transpose)
-24–
+24
Adjusts the pitch in
semitone units.
MONO/
POLY
POLY
Sets the Voice to
Polyphonic mode.
MONO-
FULL
Sets the Voice to
Monophonic mode.
Portamento will be
applied to all notes.
MONO-
LGATO
(Mono-
Legato)
Sets the Voice to
Monophonic mode.
Portamento will be
applied only to notes
played legato.
PORTA
(Portamento
Time)
0–127
Set the portamento
time.
PB
(Pitch Bend
Range)
-24–
+24
Sets the pitch bend
range in semitone
units.
TR CH
(MIDI trans-
mit channel)
1–16,
off
Sets the MIDI trans-
mit channel.
When set to “off,” no
data is transmitted.
RV CH
(MIDI
receive
channel)
All,
1–16
Sets the MIDI
receive channel.
When set to “ALL,”
data is received on
all channels.
CONTROL ON, off
Sets whether or not
MIDI Control is to be
used.
MIDI Control
Change messages
specifically for the
reface will be trans-
mitted if a setting is
changed in the FM
section ([FREQ],
[LEVEL], [ALGO],
and [FB] buttons)
while MIDI Control is
turned on. If these
messages are
received, the FM
section’s settings will
change accordingly.
LOCAL
(Local
Control)
ON, off
Turns Local Control
on or off.
When set to “off,” the
reface’s internal tone
generator and key-
board are discon-
nected from one
another; when set to
“ON” they are con-
nected.