VTech 3S Crib Toy User Manual


  Open as PDF
of 44
 
5
Charging and Recharging the Batteries
The rechargeable batteries should be fully charged before the first use. To charge
and recharge the batteries, please follow the instructions below.
1. Make sure the battery packs are installed in the tablet.
2. Plug one end of the AC adapter into the power jack on the InnoTab
®
3S and
plug the other end into a wall outlet.
Note: The AC adapter is not a toy and should only be handled by an adult.
3. You can continue to use the InnoTab
®
3S while the AC adapter is connected, but
the batteries will not charge while the InnoTab
®
3S is on. When you’re done playing,
turn the power off and leave the tablet connected to a wall outlet to charge it.
4. The green light on the tablet will flash to indicate charging is in progress.
When the batteries are fully charged the light will turn off. A full charge takes
about 4.5 hours with the AC adapter that’s included in the package.
Note: If the green light on the tablet flashes very quickly during charging, the
battery packs may not be connected properly. Please reinstall the battery
packs and try again.
Important Notes:
• MakesuretheInnoTab
®
3S is turned off before charging.
• Thetabletwillchargeattemperaruresbetween41°F~95°F(5°C~35°C).
If the tablet is not charging properly, please move it to a location with a
suitable temperature.
• Batteryremovalandreplacementshouldonlybedonebyanadult.
• KeeptheconnectorpinsontheInnoTab
®
3S and the metal contacts on the
battery packs clean for optimal performance.
• DisconnectthetabletfromtheACadapterandremovethebatterypacks
before cleaning.
• Forbestresults,pleaseusetheACadapterthatisincludedwiththispackage.
Warning : Do not allow any metal objects to touch the metal contacts on the battery
packs or the contact pins on the InnoTab
®
3S.
Battery Notice
• Donotmixoldandnewbatteries.
• Donotmixbatteriesofdifferenttypes:alkaline,standard(carbon-zinc),or
rechargeable (Ni-MH).
• Onlybatteriesofthesameorequivalenttypeasrecommendedaretobeused.
•Alwaysinsertbatteriesproperlymatchingtheplus(+) and minus (-) signs.
•Donotshort-circuitthesupplyterminals.
G
E
T
T
i
N
G
S
T
a
r
T
E
d
 previous next