VTech 3S Crib Toy User Manual


  Open as PDF
of 44
 
4
Slide these switches to open the battery doors.
Always replace the InnoTab
®
3S battery doors
after changing batteries.
microSD Memory Card Slot Insert a microSD memory card (not included).
(NOTE: InnoTab
®
3S is compatible with
microSD memory cards up to 32GB.)
Battery Compartments Insert 4 "AA" batteries (not included) or the
rechargeable battery packs. For battery installation
instructions, please see the section below.
How to Attach the Stylus
Tie one end of the stylus string to the stylus and the other end to the stylus
fastener on the InnoTab
®
3S.
Installing the Rechargeable Battery Packs
1. Make sure the InnoTab
®
3S is turned off.
2. Turn the unit over. Slide the battery door lock switches forward and push
the battery covers off to each side to remove them.
3. InsertBatteryPack①intothecompartmentontherightsideandBattery
Pack② into the compartment on the left side.
•Insertthebatterypackintotheconnectorslotfirst.
•Thenpressthebatterypackdownuntilitrestsinplace.
4. Replace the battery covers.
G
E
T
T
i
N
G
S
T
a
r
T
E
d
Battery Door Lock Sliding
Switches
 previous next