Filter
Top Products
19
Rear Panel
1234
56789
1. Power In: Use the included power adapter (12 V DC, 2 A, center-positive) to connect NV
to a power outlet. While the power is switched off, plug the cable into NV first, then plug
the cable into a power outlet.
2. Power Switch: Turns NV on and off. Turn on NV after all input devices have been
connected and before you turn on amplifiers. Turn off amplifiers before you turn off NV.
3. Cable Restraint: You can secure cables to this restraint to help avoid disconnecting
them accidentally.
4. USB: This USB connection sends and receives audio and control information from a
connected computer.
5. Master Outputs (XLR): Connect these low-impedance XLR outputs to a PA system or
powered monitors. The level of these outputs is controlled with the Master knob on the
top panel.
6. Master Outputs (RCA): Use standard RCA cables to connect these outputs to a speaker
or amplifier system. The level of these outputs is controlled by the Master knob on the
top panel.
7. Booth Outputs (RCA): Use standard RCA cables to connect these outputs to a booth
monitoring system. The level of these outputs is controlled by the Booth knob on the top
panel.
8. Line Inputs (RCA): Connect line-level devices, such as CD players, samplers or audio
interfaces, to these inputs.
9. Mic Input (1/4" / 6.35 mm): Connect a 1/4" (6.35 mm) microphone to this input. This
input's audio signal is routed directly to the Master Outputs.