Filter
Top Products
12
Effects Controls
49. FX 1, FX 2, FX 3: These buttons have different functions on each Deck depending on the
current FX Mode.
• Single-FX Mode: FX 1 activates or deactivates the effect; FX 2 activates or deactivates
the first effect parameter; FX 3 activates or deactivates the second effect parameter.
Press and hold Shift and press FX 1 to select the desired effect.
• Multi-FX Mode: The buttons activate or deactivate the first, second, and third effects in
the effects chain, respectively. Press and hold Shift and press one of the buttons to
select the effect for that point in the effects chain.
50. FX 1 Knob, FX 2 Knob, FX 3 Knob: These knobs have different functions on each Deck
depending on the current FX Mode.
• Single-FX Mode: the FX 1 Knob controls the "wet-dry" balance of the effect; the FX 2
Knob controls the first effect parameter; the FX 3 Knob controls the second effect
parameter. When Touch Mode is activated, touch the FX 1 Knob to activate its effect,
and release the knob to deactivate it.
• Multi-FX Mode: The knobs control the "wet-dry" balance of the first, second, and third
effects in the effects chain, respectively. When Touch Mode is activated, touch a knob to
activate its effect, and release the knob to deactivate it.
51. Beat / Mode: Tap this button repeatedly at the desired tempo to set the rate of the effects'
low-frequency oscillators (LFOs). Press and hold this button to reset Beat Multiplier to the
Deck's BPM. Press and hold Shift and then press this button to switch between Single-FX
Mode and Multi-FX Mode.
52. Beat Knob: Turn this knob to set the Time Division for the selected effects.
53. FX Assign: Use these buttons to apply Effect A and/or B to the corresponding channel. You
can apply Effect A and/or B to the entire Program Mix by using the FX Send buttons below
the Master Volume knob. (Each effect can be applied to any or all of the four channels and/or
the Program Mix.)
54. Channel Filter: Turn this knob to adjust the filter on the corresponding channel. The type of
filter it adjusts will depend on the Filter Mode button.
55. Filter Mode: Press this button to change the Filter Mode, which affects the Channel Filter
knobs:
• Off: When this button is off, the Channel Filter knob will apply and adjust a low-pass
filter to the corresponding channel when turned counter-clockwise or a high-pass filter
when turned clockwise.
• Filter-Roll Mode: Press this button once to activate Filter-Roll Mode (the button will light
solid red). The Channel Filter knob will apply and adjust a low-pass filter to the
corresponding channel when turned counter-clockwise or a high-pass filter when turned
clockwise. In addition, it will apply a Loop Roll to the filter and will decrease in length as
the knob moves further away from the center position. Press this button once to
deactivate Filter-Roll Mode.
• Filter-FX Mode: Press and hold Shift and then press this button to activate Filter-FX
Mode (the button will flash red). The Channel Filter knob will apply and adjust a low-
pass filter to the corresponding channel when turned counter-clockwise or a high-pass
filter when turned clockwise. In addition, it will adjust Parameter 1 of the effects applied
to that channel as the knob moves further away from the center position. Press this
button once to deactivate Filter-FX Mode.