Filter
Top Products
48
8) Using the thumbscrews, replace spouts (A) and (B) and spout packings (A) and (B) in
their correct positions.
9) Allow the icemaker to sit for about 10 minutes before operation.
10) Move the ush switch to the "ICE" position, then turn on the power supply. Replace the
top panel and the front panel in their correct positions. Make ice using the solution until
the icemaker stops making ice.
11) Remove the front panel.
12) Move the ush switch to the"FLUSH" position to drain the remainder of the solution.
13) After the solution is drained, move the ush switch to the "ICE" position.
14) Replace the front panel in its correct position.
15) Open the water supply line shut-off valve and supply water to the reservoir.
16) When the gear motor starts, remove the front panel and turn off the power supply.
17) Drain out all water from the water line. See 2) and 3).
18) Move the ush switch to the "ICE" position and run the icemaker.
19) Turn off the power supply after 30 minutes.
20) Pour warm water into the storage bin to melt all ice, then clean the bin liner with the
solution.
21) Flush out any solution from the storage bin.
22) Turn on the power supply and start the automatic icemaking process.
IMPORTANT
1. After cleaning, do not use ice made from the sanitizing solution. Be careful
not to leave any solution in the storage bin.
2. Follow carefully any instructions provided with the bottles of cleaning or
sanitizing solution.
3. Never run the icemaker when the reservoir is empty.