GTO 10 Safety Gate User Manual


 
GTO 4000XLS Instruction Manual © 01.10.12 29
ADDITIONAL ACCESSORIES
Photo Beams [R4222]
Primary “through beam” photo beam device. Provides “non-contact” entrapment
protection.
Pin Lock [FM345]
Use as a substitute for the clevis pin at the front mount of the PRO-SW4000XLS to
prevent theft of the operator.
• PinLock10-pack:tenPinLockskeyedalike[FM345KA].
Push Button Control [RB101]
Wire this unlit push button directly to your gate operator for simple open/close/stop
operation from up to 1000 ft. away. Use 16 gauge low-voltage wire.
Replacement Transformer [RB570]
Standard 18 volt, 2200 mA AC transformer included with the 4000XLS to maintain
battery charge.
Gate Grounding Kit [R4196]
The purpose of the grounding kit is to REDUCE THE RISK of damage to electronic
equipment from lightning strikes. There is no protection or grounding system that
can completely eliminate this risk.
HARDWARE ACCESSORIES
Push To Open Bracket [R4KPTO]
Required when the 4000XLS must push a gate open (arm extends to open), such as
away from a sloping driveway or where space prevents gate from opening into the
property (pull to open). Order two brackets for a dual swing gate installation.
Column Mount Lock Receiver [433IH]
For use with the Automatic Gate Lock or Bulldog Pedestrian Gate Lock when
mounting on brick columns or applications with limited space.